In the world of positive displacement pumping, reduced speed operation is a common requirement.  High viscosity liquids, shear sensitive liquids, abrasive liquids, or any combination thereof require the pump speed to be reduced from synchronous motor speeds.

One of the biggest limitations of a traditional centrifugal pump is its inability to reverse the direction of flow. By design it can only be run in one rotation and one direction of flow. Liquid enters the eye of the impeller at the suction port (typically on the front of the pump), is pushed out radially, and exits the pump at the discharge port (typically on top of the pump). For most centrifugal pumps the suction port is larger than the discharge port to better feed liquid into the pump, and to remove any confusion as to which port is “in” and which port is “out.”  Rotation arrows can be found cast onto the pump or printed on the nameplate to make it perfectly clear that these pumps run in one direction of rotation and one direction of flow.

A gentleman once contacted me to let me know that he’d cracked a head, an impressive, but not entirely unheard-of feat.  When I asked how this had happened he admitted “well, I was wailing on it pretty hard”; I appreciated his honesty.  What followed was a 30-minute conversation full of mis-assumptions and confusion.  At the conclusion I discovered that he was not talking about a head (as in the end plate of a gear pump) but rather a head (as in the top of a snare drum).  An internet search for “head” had landed him on our site by mistake.

Explore how Viking gear pumps improve natural gas dehydration with glycol in high-temp, high-pressure conditions.