Welcome, in this quick tip video we will guide you through the installation of a stuffing box component mechanical seal in Viking Pump’s with the U-Plus™ bracket. First, place the seal collar onto the shaft with the stepped side facing the end of the shaft. Insert a hex head wrench into the seal access hole and into a set screw to hold the seal collar in place. Install the seal installation sleeve with the taper toward the end of the shaft. Lubricate the shaft and inside of the rotary member of the seal.

Welcome, in this quick tip video we will guide you through the installation of a double lip seal in an RTPg Series™ truck pump. This video applies to these pump models… To begin, place a new lip seal with the flat side up into the seal holder. Using an arbor press and a press fixture large enough to cover the seal, press in the seal until it is fully seated. Next, place the second lip seal with the flat side up into the seal spacer and press in the seal. Using your thumbs, press in the lip seal and spacer assembly into the seal holder. Make sure the lip seal is facing up.

Welcome. In this Quick Tip video, we will show you how to switch between flat gaskets or o-rings in Viking pumps with the ProPort™ casing. The bracket, head, and ports will each have a flat gasket or o-ring for sealing. Depending on application requirements, users can switch between these elastomers as needed. Before you begin please consult the appropriate technical service manual for safety information. A copy of the latest revision can be found at vikingpump.com.

Welcome, in this video quick tip video we will guide you through the installation of Viking Pump’s O-Pro® Cartridge seal into a pump with the U-Plus™ bracket. Before installing the new seal, ensure the shaft is free of any debris or wear any burrs can damage o-rings upon installation. First, prepare the O-Pro® Cartridge seal for installation. Lubricate and install the two internal o-rings into the O-Pro® cartridge seal gland. Apply gasket sealant to the O-Pro® Cartridge and place a gasket. Give the gasket a quarter turn and then flip, to ensure both sides have a continuous bead of sealant.

Welcome, in this video quick tip video we will guide you through the installation of Viking Pump’s O-Pro® Guard seal into a pump with the U-Plus™ bracket. Please consult the appropriate technical service manual for safety information. A copy of the latest revision can be found on our website at vikingpump.com. Before installing the new seal, ensure the shaft is free of any debris or wear. Any burrs can damage o-rings upon installation. You can now prepare the O-Pro® Guard seal for installation. First, install the three set screws into the sleeve.